¶ What is it?
¶ pi-Hydroponics - The DIY hydroponic system controller
Oceanberry makes your aquarium management easy and professional.
Compatible with:
- Raspberry Pi Zero W
- Raspberry Pi Zero 2W (preferred - faster)
- Raspberry Pi 3b+
- Raspberry Pi 4
You can easily control up 12 power outlets, monitor power usage, monitor temperature and pH and EC measurements and control the water level using non-contact sensors.
Then you can control remotely your aquarium using an elegant and powerful dashboard and receive push notification on your mobile if something is wrong on your tank.
pi-Hydroponics is compact and easy to make.
It has been tested successfully for over 2 years.
You won’t have any electrical noise coming from your aquarium system (like pumps, skimmer and heater) since the sensors are electrically isolated).
Once built your controller, you need to attach ant Raspberry and burn the image on the SD card.
The controller is composed by:
- Raspberry Pi Zero W/ 2W / Pi2 / Pi3 / Pi4
- Controller
- Tasmota flashed Power Bar (up to 4 x 3 modules = 12 outlets)
- Ph Probe sensor (optional)
- TDS/EC probe sensor
- Water Temperature sensor
- Ambient temperature sensor
- CO2 Carbon Dioxide sensor
- Water Level sensors (optional)
¶ Key features:
- Compact design
- Affordable - about 100$ (ten time less than professional hydroponic system)
- Professional and reliable pH and Temperature readings (electrical isolated probes)
- up to 12 power outlets
- Modern dashboard (also for mobile and tablet)
- Push notifications
- Remote control
- Can work on existing wifi network or in AP mode.
- Import / export system telemetry
- On board Buzzer alert
- Configurable alerts (water level, pH, temperature etc)
- Outlets scheduler
- Power consumption monitor (for enabled tasmota hardware)
- OLED display
- Temperature controlled internal super silent fan
- pH probe calibration tool
- Electrical conductivity measurement
- Smart nutrient doser (optional)
- CO2 Carbon dioxide measurement (optional)
.jpg)